LiPo Battery Voltage Chart

LITHIUM BATTERY GUIDES · VOLTAGE CHARTS

LiPo Battery Voltage Chart

A LiPo battery’s maximum voltage is 4.20 volts per cell — the most-searched LiPo question on this site, and the safety-critical number. Charge a standard LiPo cell above 4.20V and you damage it; it can swell or catch fire. A 3S pack must never exceed 12.6V, a 4S pack 16.8V, a 6S pack 25.2V. The limits are per cell, so they scale exactly with the number of cells in series — which is why this page is a table, not a paragraph.

The table below gives the resting voltage of a standard 3.7V-nominal LiPo cell from 0% to 100% state of charge, plus 1S–6S pack voltages. Read it at rest — after the pack has sat at least 30 minutes with no charge or discharge, at about 25°C. Under load the voltage sags; just after charging it reads high. Two mistakes are covered below: LiHV cells charge to 4.35V per cell, and a fully charged LiPo is not a stored LiPo — store at 3.80–3.85V per cell.

NEW — Table 1: LiPo voltage vs state of charge

Resting voltage, no load, after ≥30 minutes rest, ≈25°C, standard 3.7V-nominal LiPo cells. Pack voltages are cell voltage × series count, rounded to one decimal (1S column shows the cell value exactly). Anchors verified (VoltageBasics, Jackery, BatterySkills): 100% = 4.20V, 50% = 3.78V, 40% = 3.70V, 0% = 3.00V. The 90/80/70/60/30/20/10% rows are smooth interpolations — no single published table confirms each step.

SOC Cell 1S 2S 3S 4S 6S
100% 4.20 V 4.20 V 8.4 V 12.6 V 16.8 V 25.2 V
90% 4.10 V 4.10 V 8.2 V 12.3 V 16.4 V 24.6 V
80% 4.00 V 4.00 V 8.0 V 12.0 V 16.0 V 24.0 V
70% 3.90 V 3.90 V 7.8 V 11.7 V 15.6 V 23.4 V
60% 3.85 V 3.85 V 7.7 V 11.6 V 15.4 V 23.1 V
50% 3.78 V 3.78 V 7.6 V 11.3 V 15.1 V 22.7 V
40% 3.70 V 3.70 V 7.4 V 11.1 V 14.8 V 22.2 V
30% 3.60 V 3.60 V 7.2 V 10.8 V 14.4 V 21.6 V
20% 3.50 V 3.50 V 7.0 V 10.5 V 14.0 V 21.0 V
10% 3.40 V 3.40 V 6.8 V 10.2 V 13.6 V 20.4 V
0% 3.00 V 3.00 V 6.0 V 9.0 V 12.0 V 18.0 V

Note: “Maximum LiPo voltage is 4.20V per cell. Do not discharge below 3.0V per cell (9.0V on a 3S pack) — that is the low cutoff, not a usable empty. Storage charge is 3.80–3.85V per cell.”

NEW — Table 2: LiPo vs LiHV comparison

All figures verified 16 Nov 2026 against Grepow (updated 2026-09-16), Ufine Battery, ChinaHobbyLine (6 Nov 2025) and DroneCamps — the same figures already applied to the voltage-chart ready HTML.

Standard LiPo High-voltage LiPo (LiHV)
Nominal voltage per cell 3.7 V 3.8 V
Maximum charge voltage per cell 4.20 V 4.35 V
Maximum charge, 3S pack 12.6 V 13.1 V (4.35 × 3 = 13.05, rounded)
Maximum charge, 6S pack 25.2 V 26.1 V (4.35 × 6)
Storage voltage per cell 3.80–3.85 V 3.80–3.85 V
Low cutoff per cell ≈3.0 V ≈3.0 V
Typical use Drones, RC cars/boats, FPV, portable electronics High-performance drones and RC where extra voltage is wanted
Charger setting Standard LiPo profile (4.20V) LiHV profile only (4.35V) — do not mix profiles

Note: “If a pack is not labelled LiHV, charge it as a standard LiPo at 4.20V per cell.”

Worked example — a 3S pack at full charge and at storage

Take a common 3S LiPo pack — three cells in series.

  • Full charge: 4.20V × 3 cells = 12.6V. If your charger shows more, stop — a cell is overcharged.
  • Nominal (label) voltage: 3.7V × 3 = 11.1V — the voltage printed on the pack label (“3S 11.1V”).
  • Storage: 3.80V × 3 = 11.4V at the low end, 3.85V × 3 = 11.6V at the high end. A 3S pack at 11.4–11.6V is correctly stored; at 12.6V it is full, not stored.
  • Empty: 3.00V × 3 = 9.0V. Land well before this; most pilots treat about 3.5V per cell (10.5V on 3S, the 20% row of Table 1) as the practical “time to land” point.

Storage-safety note

  • Never store a LiPo fully charged. A pack left at 4.20V per cell (12.6V on 3S) for days or weeks loses capacity faster and is more hazardous if damaged. Bring it to 3.80–3.85V per cell (11.4–11.6V on 3S) with your charger’s storage mode.
  • Never store a LiPo empty either. A pack left at or below 3.0V per cell can drop further on its own and may not recover. Storage voltage is the middle ground, roughly 40–50% charge.
  • Check stored packs regularly and bring any cell that has drifted out of the 3.80–3.85V range back to storage voltage. Store in a fireproof LiPo bag or container, away from flammable material, and never charge unattended. A swollen, punctured or hot pack must not be charged — dispose of it under local battery-recycling rules.
  • The 3.80–3.85V/cell figures are verified against ChinaHobbyLine, DroneCamps, Grepow and Ufine. The storage advice itself still needs one named source — see verify item 4.
RELATED RESOURCES

Related Resources

These published resources answer the next question.

full LiFePO4, Li-ion and LiPo voltage chartestimate SOC from a LiPo voltage readingLiPo storage voltage in detailcalculate runtime for your LiPo pack3S pack voltage calculatorLiFePO4 vs LiPo chemistry compared

QUESTIONS & ANSWERS

LiPo Battery Voltage Chart: Frequently Asked Questions

Short answers to the questions visitors ask most.

What is the maximum voltage of a LiPo battery?+

4.20V per cell — 8.4V for 2S, 12.6V for 3S, 16.8V for 4S and 25.2V for 6S. Never charge above it. LiHV cells are different: they charge to 4.35V per cell and need a LiHV charger profile.

What voltage should I store my LiPo battery at?+

3.80–3.85V per cell — 11.4–11.6V for a 3S pack, 22.8–23.1V for a 6S pack, roughly 40–50% charge. Use your charger’s storage mode.

What is the voltage of a fully charged 3S LiPo?+

12.6V (4.20V × 3 cells). Its nominal label voltage is 11.1V and its storage voltage is 11.4–11.6V. A 3S pack reading 12.6V is full — not stored.

What is the difference between LiPo and LiHV?+

LiHV cells are 3.8V nominal and charge to 4.35V per cell, versus 3.7V nominal and 4.20V maximum for standard LiPo. Storage voltage is the same for both (3.80–3.85V per cell). Never mix the charger profiles.

What voltage is a LiPo battery at 50% charge?+

About 3.78V per cell at rest — 11.3V on a 3S pack, 22.7V on a 6S pack. Voltage-based SOC is approximate, so measure at rest, after at least 30 minutes with no charge or discharge, at about 25°C.

Sources and Verification Status

Author: Saqib Jillani · Reviewer: lithiumbattery.info/ Editorial Team

  • Page-specific sources to cite (named, not just org homepages): Grepow, “How to Fully Charge High Voltage LiPos” (updated 2026-09-16) — LiPo 3.7V / 4.2V max; LiHV 3.8V / 4.35V max; store at ~3.8V/cell. Ufine Battery, “What is a LiHV Battery” — LiHV 4.35V vs LiPo 4.20V; store at 3.8V/cell. ChinaHobbyLine (6 Nov 2025) — LiHV max 4.35V/cell, storage 3.80–3.85V/cell. DroneCamps LiPo Battery Guide — 4.20V full (4.35V LiHV), storage 3.80–3.85V. VoltageBasics / Jackery / BatterySkills — SOC anchors: 100% 4.20V, 50% ≈3.70–3.78V, 40% 3.70V, 0% 3.00V. Battery University BU-409 — cite for the storage-safety note only after checking it; not yet verified here.